13
Chapter 2: Get Started
Rushmore Monitor Cabling
The Rushmore DVI card supports output to either
analog or digital display devices. To connect the
Rushmore DVI card to the desired display
devices, perform the following steps:
1.
Attach the supplied DVI Y-cable(s) to the installed
Rushmore DVI card and tighten the thumbscrews.
NOTE: Monitors 1 and 3 will reside on the Y-cable
connected to the lower Rushmore card connector.
Monitors 2 and 4 will reside on the Y-cable
connected to the upper Rushmore card connector.
⌦
WARNING! Make sure the cable connector is
mated correctly to the connector on the
Rushmore card. It is possible to plug the
cable into the card incorrectly. This could
cause damage to the cable connector.
2.
If you plan to output display from the
Rushmore DVI card to a DVI device,
such as a
digital flat panel or digital projector, attach the
supplied DVI Y-cable(s) directly to your DVI device
cable(s) and tighten the thumbscrews (Figure 4).
Cable installation is complete.
