7
4
Adjusting the Spray Gun
a. Locate the Solution Flow Knob (#10) on the T6000 diagram.
b. Turning the Solution Flow Knob clockwise reduces and will eventually stop the flow of solution. DO NOT
over-tighten the screw as this will cause damage to the end of the needle. Once the trigger cannot be
pulled back there is no point in tightening the screw down more, this will only damage the end of the
needle.
c. Turning the Solution Flow Knob anti or counter clockwise will increase the flow of solution.
d. In general, 1 ½ - 2 full turn from the fully closed position will provide a good solution flow. You may find
that you want more or less solution. You can adjust the Solution Flow Knob to your desired setting.
NOTE:
Opening the Solution Flow Knob more than 3 turns will not increase the solution flow and will in fact
decrease the efficiency of your Spray Gun.
e. In general, hold the T6000 Spray Gun 4” (10cm) from the person being sprayed. Moving the Spray Gun
back will increase the size of the mist pattern. Moving the Spray Gun closer will decrease the size of the mist
pattern. The further away you hold the Spray Gun, the more you will need to increase the solution flow thus
causing abnormal amounts of airborne solution (overspray).
f.
Holding the Spray Gun closer to the person being sprayed along with a minimum flow of solution will provide
the best results, no streaks or running solution and virtually no mist in the spray area.
g. Be sure to move the Spray Gun at a slow, steady speed keeping the distance of the Spray Gun the same
through the entire application. This will ensure perfect results. It is actually very easy. Practice a few times
and you will be an expert.
h. It is best to hold the Spray Gun in a vertical position when spraying. If you want to change the direction of the
mist pattern, rotate the position of the air cap rather than turning the Spray Gun on its side.
i.
Always hold or store the Spray Gun in a vertical position. A slot in the T100 Turbo Unit is provided to hold
and store the Spray Gun. It is a good habit to use it when you are not spraying.
j.
Do not over-tighten the solution flow screw (#10) as this will damage the end of the needle point. Tighten the
screw until the needle cannot be pulled back. Once this point is reached there is no point in turning the
solution slow screw anymore as this will only cause damage to the needle point.
Summary of Contents for Mini-Mist PRO
Page 12: ...12 8 Diagram...
