4. WIRE THE RECEIVER HARNESS
Wire the receiver harness according to the
wiring diagram (see Fig 5.) For eas of
installation the wires are color coded. For
most standard gate and door installations
you will wire th eopen input of your gate
operator or garage door, with the commona
and NO (normally open) contact of either
relay 1, 2 or both. See Fig 5.
6. INSTALLATION
A. Mount the receiver in a safe and convenient location on your instllation. Remember to
take care to avoid items that may cause interference with the receiver such as electric
motors, etc. The receiver can be attached with either the mounting screw holes of the ho
using or by using industrial strength velcro.
B. Install the coax antenna (provided) bys crewing it onto the antenna mount which
protrudes from the top of the housing.
C. After you have conmpleted the installation check for operational range from various
areas around the installation. If the range is less than desired, try re-positioning the
antenna, receiver, or both and re-test the range.
5. TESTING
A. Attach the wiring harness to the receiver. See Fig 6.
B. Verify the receiver has power. This can be verified by observing if LED1 and LED2 are
illuminated. See Fig 7.
C. Push the button on a transmitter that has been programmed to the same code as the
receiver. If you hear the relay click and see the LED flash quickly, you have successfully
wired the receiver.
Fig. 7
Fig. 8
D. Close the access door on the receiver. See Fig. 8
www.ApolloGateOpeners.com | (800) 878-7829 | [email protected]
