Apollo AIM-4SL, Hardware Manual

Page: 3 / 52

W A R N I N G
HIGH VOLTAGE, AC MAIN POWER SHOULD ONLY BE CONNECTED BY QUALIFIED,
LICENSED ELECTRICIANS. ALL APPLICABLE LAWS AND CODES MUST BE FOLLOWED. IF
THIS PRECAUTION IS NOT OBSERVED, PERSONAL INJURY OR DEATH COULD OCCUR
Power should not be applied to the system until after the installation has been completed. If this
precaution is not observed, personal injury or death could occur, and the equipment could be
damaged beyond repair.
-Verify that the external circuit breaker which supplies power to the device power supply is turned
off prior to installation.
-Verify that the output voltage of the power supply is within specifications prior to connection to the
device.
C A U T I O N
Several important procedures should be followed to prevent electro-static discharge (ESD) damage
to sensitive CMOS integrated circuits and modules.
-All transport of electronic components, including completed reader assemblies, should be in static
shield packaging and containers.
-Handle all ESD sensitive components at an approved static controlled work station. These work
stations consist of a desk mat, floor mat and a ESD wrist strap. Work stations are available from
various vendors including the 3M company.
FCC Compliance Statement
This device complies with Part 15 of FCC Rules. Operation is subject to the following two
conditions:
1.This device may not cause harmful interference, and
2.This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this device in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his/her own
expense. The user is advised that any equipment changes or modifications not expressly approved
by the party responsible for compliance would void the compliance to FCC regulations and
therefore, the user's authority to operate the equipment.
IMPORTANT INFORMATION