Apollo Advantage 6000 Series, Operating Manual

Page: 38 / 61

Revision 5 - 38 - November 2017
Select Water Temperature
First bath of the day.
Note: A safe bathing temperature is 95-
105°F (35-41°C). Water must be entering
the system (Manual Filling or Rapid Fill™
Reservoir Filling) in order for the
temperature gauge to read accurately.
Tub Filling from Manual Valve
Attention: Monitor water temperature. Do
not use if water temperature is above 105°F
(41°C).
1. Close Tub Drain.
2. Turn Tub Fill Valve on.
3. Adjust Mixing Valve to maintain a
water temperature of 95-105°F (35-
41°C).
4. Turn Tub Fill Valve off when the tub is
filled to desired level.
Operate Shower Wand
1. Pull Shower Wand out of holder, direct
wand away from resident.
2. Turn Shower Knob on.
3. Adjust Mixing Valve to maintain a
water temperature of 95-105°F (35-
41°C).
4. Turn Shower Knob off.
5. Retract Shower Wand.
Air Spa Operation
1. Push the On/Off Button to start the
Blower.
2. Adjust the Blower speed by pushing
the +/- Button.
3. Push the Pulse Button to enter Pulse
Mode 1; push it again to enter Pulse
Mode 2.
4. Push the On/Off Button to stop the
Blower.
Note: The Air Spa Advantage™ Bathing
System is designed to automatically shut off
after 20 minutes of continuous use. It is also
equipped with an infection control feature
that automatically runs a purge cycle that
blows the internal air lines dry after 20
minutes of non-use. If the bath is used
before 20 minutes, the automatic purge
cycle timer is reset.
Drain Bathing System
1. Open Tub Drain.
Rapid Fill™ Reservoir Filling (if
applicable)
Attention: Monitor water temperature. Do
not use if water temperature is above 105°F
(41°C).
1. Push the Tub Fill Lever to Close.
2. Turn the Reservoir Fill Valve on.
3. Adjust the Mixing Valve to maintain a
water temperature of 95-105°F (35-
41°C).
4. Verify the reservoir water temperature
is about the same as the incoming
water temperature.
5. Verify the water shuts off when the
reservoir is full.
Note: Water will continue to run refilling
the reservoir after the tub has filled unless
the Reservoir Fill Valve is turned off.
Tub Filling from Rapid Fill™
Reservoir (if applicable)
1. Pull the Tub Fill Lever to Open.
2. Feel water entering the tub to assure
comfortable temperature. If the water is
uncomfortably warm, close the Tub
Fill Lever, drain the tub, and contact
maintenance.
Drain Rapid Fill™ Reservoir
1. Turn Reservoir Fill Valve off.
2. Pull the Tub Fill Lever to Open.
3. Open Tub Drain.