Apollo Sprayers MAXI-MISER PBC7600-GTO, Instruction Manual

Page: 14 / 20

13
7. Air Pressure and Viscosity
When using your ™ spray system it is important to understand the nature of the coating you are spraying and the viscosity.
Fairly thin materials like Base coats can generally be sprayed with approximately 2-4 PSI. Medium bodied materials such as
sealers will require a little more air pressure, approximately 4-6 PSI. High Solids and heavy viscosity materials are going to
require 6 PSI or more to atomize them nicely. Always use the minimal amount of air pressure possible to achieve the best
results.
Chart D
Turbine Performance
Suggested Flow Air Pressure Coating Types
2-4 PSI Low-Medium Viscosity Materials
4-6 PSI Medium Viscosity Materials
6+ PSI High Viscosity Materials
8. Record of Spray Gun Use
Record Of Spray Gun Use
Model Serial # Date Purchased
Date Hours Of Use Total Hours
Turbine Recommended Maintenance: Clean and/or change pre-filters and/or cartridge filters every 50 hours or when
necessary. See Accessories Page for appropriate filter replacement for your model.