SENSOR MODELS
TS-100 fan-aspirated radiation shields accommodate multiple air temperature and humidity sensors using sensor
port adapters. The following standard port adapter options are available (probes not included, the TS-110 includes
the ST-110 thermistor, the TS-120 includes the EE08-SS humidity probe, the TS-130 includes both the and EE08-SS
and ST-110):
Apogee Instruments model ST-110
(thermistor for air temperature)
Apogee Instruments model EE08-SS
(probe for air temperature and humidity)
Apogee Instruments model ST-300
(PRT option for air temperature)
Campbell Scientific model CS215
(probe for air temperature and humidity)
Vaisala models HMP155, HMP110, and HMP60
(probes for air temperature and humidity)
Rotronic model HC2-S3*
(probe for air temperature and humidity)
E + E models EE071
(probes for air temperature and humidity)
All sensor port adapters are capable of holding an ST-110 or ST-300 (user selected) air temperature sensor and a
temperature/humidity probe (if desired).
*If the Rotronic HC2-S3 probe is used with the E3 Active Set module, it must be water-proofed before use with the
Apogee TS-100 radiation shield. The E3 Active Set module is not water proof (water can infiltrate at the point
where the cable enters the housing). A small length of water-proof heat shrink (ATUM heat shrink) can be used to
seal the gasket where the cable enters the housing for the E3 Active Set. For more detail, contact technical support
at Apogee Instruments:
Temperature sensor model number and serial
number are located near the pigtail leads on the
sensor cable. If you need the manufacturing date
of your sensor, please contact Apogee Instruments
with the serial number of your sensor.
Fan-aspirated shield model and serial number are
printed on a white heat-shrink label located near
the pigtail leads on the fan cable. If you need the
manufacturing date of your sensor, please contact
Apogee Instruments with the serial number of your
sensor.
EE08-SS: Sensor model number and serial number are located on the probe
body between the connector and filter cap.