APOGEE ACOUSTICS Full Range Ribbon Speaker System, Owner'S Manual And Assembly Instructions

Page: 7 / 25

(5) Place the right midrange tweeter, MRT-R on boxes A and B. (see
FIG. 2). The bottom of the MRT-R should be toward speaker position.
a) Remove the white foam end caps.
b) Remove top and bottom corrugations.
c) Do not rotate MRT during this procedure.
(6) Carefully move the midrange tweeter toward the woofer until they
ople should be involved in this process. butt. Two pe
Do not slide the midrange tweeter but lift gently for this
process.
(7) Assembly of woofer and MRT.
a) Align the 2 holes in the Top and Bottom steel plates. Use
the Drift Punch located between the two holes for the alignment.
b) Screw MRT and Woofer together with 3/4" long 1/4-20 flat head
Cap Screws. A "T" handle wrench is provided for this purpose.
c) Insert and turn screws 3-4 turns until all 4 screws are started
Then evenly tighten all 4 screws.
d) Tighten the screws loosened under item 4 to facilitate the
MRT and Woofer assembly:
(8) Open the Interface Box.
a) Remove the transformer boxes and place aside.
b) Remove Base Plates from interface box
Note Base Plates have a protective plastic coating - peel off
coating.
c) Place right Base Plate on floor between Box A and the right
speaker position.
(Page 3)