(12) Placing speaker upright.
This procedure requires two people with clean hands. The stronger
person should be positioned to lift the top section of the mid
range tweeter while the other person should be positioned to lift
the top section of the suede covered ear. A rubber mat should be
placed between the floor and the front edge of the base plate
(see
FIG. 7) to protect the floor and base plate and prevent slippage.
CAUTION!! Keep fingers clear of ribbons. Use care as speaker
weighs 300 pounds.
a) Securely holding the top half of the midrange tweeter and
the top half of the suede ear slowly rotate the speaker into
the final upright speaker position (FIG. 7).
(13) Move speaker to the nominal right speaker position in the room
(see FIG. 8)
a) Speaker may be readily moved by use of a series of rotations
about the vertical axis of the speaker.
b) Hold speaker with left and right hands at positions a and b.
c) Rotate about left corner of speaker by holding left corner of
speaker and pushing on right corner. (Hands should be held
relatively low to minimize the overturning forces).
(14) REPEAT the procedure for the Assembly of the left speaker.
Start by moving the A and B boxes to position C and D as shown in
FIG. 1.
ELECTRICAL CONNECTION TO SPEAKER
(See FIG. 5 )
(Page 5)
Summary of Contents for Full Range Ribbon Speaker System
