www.
apluslift
.com
Phone: 800-616-9618
Text: 425-300-2600 Email: [email protected]
Copyright
C
2020
TM
18 of 2
0
6 .
M a int e na nc e
6.2 Weekly Maintenance
• Check air hoses and fittings for leaks and make sure connections are tightened.
• Check all bolts, nuts, shafts, retaining clips, retainer rings, set screws and screws, ensure
they are aligned in proper place (grooves), secured, and tightened properly. Pivot
s
haft set
screws should always be checked to ensure that they are tight.
• Check the
c
ylinder
r
od
.
I
f it becomes dry, lightly oil it.
• Lubricate the grease zerks located at either end of the
p
ivot
s
haft.
• Lubricate the grease zerks at the top end of the inside frame assembly.
6.3 Six Month Annual Maintenance
• Lubricate the grease zerks located at either end of the
p
ivot
s
haft.
• Lubricate the grease zerks at the top end of the inside frame assembly.
• Squirt some oil through the bleed hole in the
p
late
e
nd of the
c
ylinder to lubricate the
p
iston.
6.4
The follow ing repairs should only be performed by a
n
APlusLift
authorized trained maintenance expert:
• Replacement of shafts / axles.
• Replacement of roll bearings.
• Replacement or rebuilding pneumatic/air cylinders.
• Check pneumatic cylinder rods and rod ends (threads) for deformation or damage.
• Check cylinder mounting to make sure it
'
s not lo
o
se and /or damage
d
.
Relocating or changing components may cause problems. Each component in the system must
be compatible; an undersized or restricted line will cause a drop in pressure. All
f
oot
p
ed
a
l,
and hose connections should be sealed and/or capped until just before use. Air hoses can
be
used to clean fittings and other components. However, the air supply must be filtered and
dry to
prevent contamination. Most important - cleanliness - contamination is the most frequent
cause of malfunction or failure of pneumatic equipment, so always use an oil/air regulator.
APlusLift MT1500 & MT1500X
I N ST ALLAT I ON M a nua l
