AVS-300 Machine Vision User Manual
31
44. BUZZER1:
Onboard buzzer.
45. FP1:
(2.0mm Pitch 2x5 Pin Header), Front panel connector.
Signal Name
Pin#
Pin#
Signal Name
1
2
POWER LED+
HDD LED-
3
4
Ground
Ground
5
6
SW+
RESET+
7
8
Ground
9
10
BUZZER-
Pin1-3:
HDD LED
, They are used to connect hard disk activity LED. The
LED blinks when the hard disk is reading or writing data.
Pin2-4:
POWER LED
, They are used to connect power LED. When the
system is powered on or under S0/S1 state, the LED is normally on; when
the system is under S4/S5 state, the LED is off.
Pin5-6:
POWER on/off Button
, They are used to connect power switch
button. The two pins are disconnected under normal condition. You may
short them temporarily to realize system startup & shutdown or awaken the
system from sleep state.
Pin7-8:
RESET Button
, They are used to connect reset button. The two
pins are dis-connected under normal condition. You may short them
temporarily to realize system reset.
Pin9-10:
BUZZER
, They are used to connect buzzer.
Note:
When connecting LEDs and buzzer, pay special attention to
the signal polarity. Make sure that the connector pins have a
one-to-one correspondence with chassis wiring, or it may
cause boot up failure.
