45
■
Measure Loss Power
●
Secure a Safe Testing Road
Measure on a long, flat road surface. (Avoid public roads when possible.) Any type of
hill or curve will increase the resistance placed on the vehicle (ie. through tire friction,
engine load) and prevent an accurate calculation.
●
Select Ghost Map Trace while in Loss Power Mode
Switch to Ghost Map Trace While in Loss Power Mode. While decelerating, make
sure that the Loss Power is plotted on the graph.
【ｍｅａｓｕｒｅ】→【ＬＯＳＳ－Ｐ】
Loss Power Input/Measure
(１)
Set Measuring Speed
Set the Measuring Speed 10km/h
ABOVE desired speed. For example, if
desired measurement speed is 90 km/h,
then set the unit to 100 km/h.
(２)
Press the Button DOWN
All previously stored Loss Power data
will be cleared.
(３)
Measure
Once at measuring speed, put the
vehicle in neutral and decelerate without
using the brake. The Loss Power will be
plotted on the graph.
(４)
Input Loss Power
Enter Loss Power Input Mode, and
match the bar graph to the plotted Ghost
Map Trace.
Follow the steps above to input Loss
Power. If Loss Power cannnot be measured
in one run, measure from 100-50km/h, 100-
60km/h etc... in multiple runs until all of the
Loss Power has been input.
Match the bar graph to
this plotted line
●
Follow all of the rules and regulations of the public highway at ALL times.
WARNING
！
Measure Mode
