3
Loading the battery and SD Card
This camera uses 2 AA alkaline
,
NiMH or CR-V3
batteries. The batteries and SD
card share the same
compartment and door
.
1.Slide the battery/SD Card cover in the direction
of the arrow, then lift to open.
2.Load the included battery in the compartment.
3.Insert the SD card into the slot.
4.Close the cover.
Battery Power Status
Full
Middle
Low
Empty
CAUTION!
1. Suggest using the high current AA
alkaline
battery, or
hight current NiMH Rechargable battery
(above 1300mAh).
2. To improve battery performance, replace all installed
batteries at the same time and keep battery away from
heat.
3. To abandon batteries, please refer to index of battery
manufacturer.
4. Do not mix battery types or it may cause a fire or
explosion. Use only one battery type at one time.
5. Batteries should be inserted in the battery compartment
with the "+" and "-" sides facing correctly.
6. While the camera indicates "Low" or "Empty" icon on
LCD display, please be aware it shows the camera is
under "Power Low" condition.
7. Under "Power Low" condition, the camera may shut
down LCD and return the lens to "Off" position.The two
LED nearby viewfinder will indicate "Power Low" status.
8. The LED behavior will be : Power LED will remain green
and the flash LED will keep blinking.
