1. NEVER start the machine before the
backing pad is installed.
2. Align the backing pad with the foam
pad's center. Otherwise, vibration may
be excessive.
3. Generally, lower speeds are
recommended for tight work areas
while higher speeds are ideal for
larger surface areas.
4. To prevent burning through paint, use
very light pressure and keep the
polisher moving constantly.
5. Use the polisher at low speeds while
polishing rough surfaces.
6. For tricky or tight areas, use
"coast-down" to polish. To do so, turn
the machine on for a few seconds to
enable it to oscillate, then turn it off
and use the residual oscillations to
polish.
Troubleshooting
1. If the polisher does not start, check the following:
• Is the power source active?
• Is the power cable on the the machine damaged?
• Are any screws on the switch loose?
• Is the switch or the speed controller damaged?
• Is the armature or stator damaged?
Best practice
2. If large sparks are visible from the side vents of the
machine, the carbon brushes may need to be replaced.
Kindly contact the Apex Customs customer support team
for further information on how to replace these.
3. If the machines become noticeably noisier over time, stop
using immediately and inspect if the bearings or counter
weight are damaged / misaligned.
Key features
?
Non-slip soft
rubber coated grip
CNC machined
counterweight
Switch self-locking button
Keep the switch locked whilst
the polisher is running
Constant speed controller
6 speed setting
3” interchangeable
backing plate
Housing lock nut
Air vents
Do not cover
during operation
4 meter cord
