Apera Instruments SX811-SS, Instruction Manual

Page: 18 / 24

- 15 -
6.4 Submenu of basic parameter setup (press key or key to switch)
P4.1. – Adjust timing storage time
1. In mode P4.0, press key to enter in mode P4.1, refer to the left
diagram: “ 00: ”: hours (0-99), “ :00 ”: minutes (0-59).
2. Press key, “ :00 ” flashes, then press key, “ 00: ” flashes.
When the number flashes, press key and key to adjust time
and press key to confirm.
3. After confirm the parameter, press key to enter in P4. 2 mode or
press key to return to the measurement mode.
P4.2. – Select temperature unit (°C—°F).
1. Press key, °C flashes, then press key, °F flashes. When the
parameter flashes, press key to confirm.
2. After confirm the parameter, press key to enter in P4.3 mode or
press key to return to the measurement mode.
P4.3. – Select backlight timing (1-2-3-On)
1. When press key,“ 1 ” flashes, then press key to select blinking
2
→
3
→
On. When the parameter flashes, press key to confirm.
Select On to turn on the backlight, the time unit is minute.
2. After confirm the parameter, press key to enter in P4.4 mode or
press key to return to the measurement mode.
P4.4. – Select automatic power-off time (10-20-30-On)
1. Press key, “ 20 ” flashes, then press key to select blinking
30
→
On
→
10. When the parameter flashes, press key to confirm.
Select On to turn on the function, the unit is day.
2. After confirm the parameter, press key to enter in P4.5 mode or
press key to return to the measurement mode.
P4.5. – Clear all the stored value
1. Press key, “ No ” flashes, then press key “ Yes ” flashes.
When the parameter flashes, press key to confirm. No : not
delete, Yes : delete.
2. After confirm the parameter, press to enter in P4.6 mode or press
key to return to the measurement mode.
P4.6. – Set automatic lock-up function
1. Press key, “ Off ” flashes, then press key, “ On ” flashes.
When the parameter flashes, press key to confirm. Off : not set,
On : set (the reading is automatically locked when stabilizes
＞
10
seconds.)
2. After confirm the parameter, press key to enter in P4.7 mode or
press key to return to the measurement mode.