Apelson UBINDJV60B, Manual

Page: 30 / 36

30
Installation
Appendix...
GB IE
Installation
Before you install the hob, make sure that
> The work surface is square and level, and no structural members interfere
with space requirements.
> The work surface is made of a heat-resistant material.
> If the hob is installed above an oven, the oven has a built-in cooling fan
> The installation will comply with all clearance requirements and applicable
standards and regulations
> A suitable isolating switch providing full disconnection from the mains power
supply is incorporated in the permanent wiring, mounted and positioned to
comply with the local wiring rules and regulations.
> The isolating switch must be of an approved type and provide a 3 mm air gap
contact separation in all poles (or in all active [phase] conductors if the local
wiring rules allow for this variation of the requirements)
> The isolating switch will be easily accessible to the customer with the hob
installed
> You consult local building authorities and by-laws if in doubt regarding
installation
> You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for
the wall surfaces surrounding the hob.
A(mm) B(mm) C(mm) D E
750 50 mini 20 mini Air intake Air exit 5mm