8
CARE AND MAINTENANCE
AGHD60GG
WARNING
Always switch off the electricity supply before
performing maintenance work. In the event of a
fault, contact customer services.
CAUTION
Use soapy water and a cloth for cleaning. Never use
abrasive powders.
Avoid banging pots and pans down on the hob.
Do not leave any empty pan on the heating zone
HOW TO KEEP YOUR HOB IN GOOD
CONDITION
Before cleaning your oven, or performing maintenance,
disconnect it from the power supply.
The appliance should be cleaned after use.
Wipe the inner and outer surface of the appliance and its
accessories with wet cloth.
Any liquid overflowing from the pan must always be
removed with a cloth.
The surface of the hob may be easily cleaned as follows:
Cleaning of enamel parts:
To maintain the features of the enamel parts, wash
frequently with soapy water.
Never use abrasive powders. Avoid leaving acid or alkaline
substances on the enamel parts (vinegar, lemon juice, salt,
tomato juice, etc.) and washing the enamel parts while
they are still warm.
Cleaning of glass/stainless steel parts:
Wash these parts with soapy water and then dry them
with a soft cloth.
The shine is maintained by regularly cleaning them with
special products normally commercially available. Never
use abrasive powders.
Cleaning of burner flame dividers:
Given that they are not fixed, the flame dividers can be
cleaned by simply removing them and washing them with
soapy water. After drying them well and checking that the
holes are not blocked, put them back into their correct
position.
FUSE
USE A 30 AMP FUSE
DOUBLE POLE SWITCHED
FUSED SPUR OUTLET
ON
GAS CONNECTION
CHANGING THE NOZZLES
Lift up the burners and unscrew the nozzle using an
dedicated tool and replace the nozzles with those designed
for LPG gas supply
CAUTION
The hob installation and burner changes must be carried
out by a competent person, e.g. a gas safe registered
fitter.
NOTE
The LPG nozzles are provided in a separate bag marked
“LPG” and if they are changed and the natural gas jets
retained then the label should be changed to “NATURAL”.
REGULATION OF BURNERS
Regulation of the “MINIMUM” position on the burners.
To regulate the minimum position on the burners, follow
the procedure below:
Turn on the burner and turn the knob to its MINIMUM
position (small flame).
Remove the knob from the tap set for standard pressure.
The knob is found on the bar of the tap itself.
Place the tap bar on the work top, use a small screwdriver
that fits the (gold) screws located at the lower part of
the tap and turn the fixing screw to
the right or left until the flame of
the burner is regulated in the most
suitable manner to MINIMUM.
Make sure that the flame does not
go out when changing the position
quickly from MAXIMUM to MINIMUM
position.
[conversion
nozzles] x 4
x1
[conversion
nozzles]
[conversion
nozzles] x 4
x1
[conversion
nozzles]
