APB-DynaSonics ProDesk-4, Owner'S Manual

Page: 20 / 40

APB-DynaSonics
20
STEREO LINE INPUT - AUX SENDS
Stereo Channel Aux Sends
The signals feeding the Aux sends are normally summed-mono mixes of the left & right side signals within the module.
For Auxes 1& 2, when switched to Stereo, the left-side channel signal feeds the Aux 1 control; the right-side channel signal
feeds the Aux 2 control. This is true for both Pre & Post signals –
however -, if Split-Track is activated, both the Post-fader and
the Pre-Aux signals have already been converted to mono by the Blend controls, so Aux 1&2 will receive a summed-mono
signal even when Stereo is selected.
Aux Level Control 1
Adjusts the level of the selected Aux feed into Aux bus 1.
Aux Level Control 2
Adjusts the level of the selected Aux feed into Aux bus 2.
Aux 1-2 Pre Switch
This switch selects the signal source for Aux sends 1 and 2 between Post-fader (Up) and the default
“Pre” signal (Down).
Aux 1-2 Stereo Switch
Reconfigures the signals feeding the individual Aux 1 and 2 level controls from a summed mono
mix to separate left & right signals; left feeds Aux-1, right feeds Aux-2.
NOTE: If Split-Track is active, both of the sends receive the same mono-mix from the either the Pre-
fader Blend control (when in Post), or the Pre-Aux Feed control (when in Pre).
Aux Level Control 3
Adjusts the level of the selected Aux feed into Aux bus 3.
Aux Level Control 4
Adjusts the level of the selected Aux feed into Aux bus 4.
Aux 3-4 Pre Switch
This switch selects the signal source for Aux mixes 3 and 4 between Post-fader (Up) or Pre (Down).
The feed to these Auxes is always a sum of the left & right channel signals.
Aux Level Control 5
Adjusts the level of the selected Aux feed into Aux bus 5.
Aux Level Control 6
Adjusts the level of the selected Aux feed into Aux bus 6.
Aux 5-6 Pre Switch
This switch selects the signal source for Aux mixes 5 and 6 between Post-fader (Up) or Pre (Down).
The feed to these Auxes is always a sum of the left & right channel signals.
Discrete Sub Woofer Feed Using Aux Sends (Aux-Fed Sub)
Aux 6 should be used if a controlled-level Subwoofer send is desired. In the Master Section, the output level control for Aux 6
can be swapped (Fader-Flip) from its default rotary control to the (Mono) 100mm fader. This gives the operator a convenient
and precise level control to adjust the Subwoofer output. See the Master Section of the manual for more details.