9
1 Power cable
2 Speed setting
3 ON/OFF switch
4 Threaded bushes for handle
5 Protective cover
6 Mounts for disc sanding pads
7 Disc sanding pads
8 Polishing sponge
9 D-handle
10 Additional handle
11 Spanner
12 Allen key
13 Carbon brushes
6. Operating instructions
6.1 Overview
6.2 Prior to starting up
6.2.1 Mounting the disc sanding pad
Make sure that the mains plug is removed from the socket. Place the spanner (position 11 in the overview) on the
hexagonal bar of the mount for disc sanding pad (position 6 in the overview), image 4. Screw the threaded bolts of
the disc sanding pad (position 7 in the overview) in clockwise direction on the polishing disc mount, image 5. Resist
using the spanner and tighten the disc sanding pad.
Figure 1: Overview 1
Figure 2: Overview 2
Figure 3: Overview 3
Figure 4: Place a wrench
Figure 5: Screw the disc sanding pad on
6.2.2 Mounting the D-handle
Make sure that the mains plug is removed from the socket.
Unscrew both the Allen screws at the side of the protective cap (position 5
in the overview) using the Allen key (position 12 in the overview), image
6, and pull the protective cap to the front.
Figure 6: Remove the protective cap
