AP Diving Ltd. APV200 Inflator Maintenance Manual
Page 14 of 30
4.11 Remove breathing module from APV200 body
- Gently pry the breathing module out.
- It might help a bit to also give the backside of the module a gentle push with your
finger, pushing through the big hole of the corrugated hose inlet.
- Make sure you pull it out straight: if you allow it to make an angle with the main body
it will get stuck. In that case push it back in all the way and start again.
4.12 Pull back end washer and back end rubber from stem assembly
- The end of the stem is split. You can wiggle the back end washer a bit and just pull it
off.
- After having removed the washer, the white back end rubber can just be taken off.
- The white back end rubber needs to be replaced during service.