6
!
Control Panel Guide
LEGEND:
1 — Digital Display
6 — External Sensor connector
1.a Top Display 7 — Main Power switch.
1.b Bottom Display 8 — Power cord attachment.
2 — Selection button. 9 — Fuse holder.
3 — Increase Button/ Enter button.
4 — Decrease Button.
5 — Status LED.
Suffix guide:
!"
#"
Set temperature for type 0 and 1 operation.
$"
#"
Actual Temperature of Sensor 1
%
"#"
Actual Temperature of Sensor 2
"
&
"#"
Actual Temperature of Internal Sensor
"
'
"#"
Set Temperature for profile.
"
(
"#"
Set duration/time (seconds) for profile.
"
1.a
5
4
3
2
6
7
Front Panel
Back Panel
9
8
1.b
7
!
OPERATING PROCEDURES
A. INITIAL PROCEDURES
1. Make sure all switches are deactivated.
2. Attach external sensor probes to the three pin socket. (#6 on
control panel guide)
3. Attach power cord to the power cord attachment (#8 on
control panel guide)
4. Plug the device to the main power source.
5. To turn the unit ON. Toggle the main power switch to ON
position (#7 on control panel guide)
B. OPERATION TYPE(MODE) SELECTION
1. Follow initial procedures, “
A. INITIAL PROCEDURES
”.
2. The display would show “
TYPE 0
”, which means Type 0
operation will be used. To select between types 0 to 2. Press
the increase or decrease buttons (#3 & #4 of control panel
guide).
3. To confirm selection and enter into operation mode using the
selected type. Press the selection button.(#2 of control panel
guide)
C. TYPE “0” OPERATION
This type of operation utilizes the internal temperature sensor
to control the heat. Using this type frees up the two extra
external temperature probes for additional monitoring. Attach the
two extra temperature probes to areas of interest such as the
bottom of the board and top of the board near the components to
be worked on for monitoring.
1.
To set the desired temperature press the selection button
repeatedly until the top display shows “
Set
”. The bottom
display would show the current set temperature followed by
a suffix “
A
”.