Aosom A91-169, Assembly & Instruction Manual, Page: 9 / 31

A s s e m b l y S t e p 4
A). Attach the Leg Developer (#08) by aligning the holes to bracket of Front Upright (#05). Secure together using
one Hex Bolt (#47) through one Washer (#55) and an additional Washer (#55) followed by one Nylon Nut (#53) as
illustrated.
B). Slide one Foam Roller (#22) onto one end of a Foam Roller Tube (#12). Next, slide the same Foam Roller Tube
(#12) through the lower hole of the Leg Developer (#08) as illustrated. Next, slide one more Foam Roller (#22) onto
the other end of the Foam Roller Tube (#12) (after it has been inserted through the lower hole).
Repeat this process with the other Foam Roller Tube (#12) and the two other Foam Rollers (#22) through the
upper hole on the Leg Developer (#08).
C). Attach the four Round End Caps (#30) on the outside of the four Foam Rollers (#22).
D). Attach the Olympic Adapter (#15) over the protruding tube of Leg Developer (#08) and secure using Quick Clip
(#39) as illustrated below.
Assembly Instructions
Hardware Required
WASHER
#55. Washer (M10) [2 Pieces]
#39. Quick Clip
#47. Hex Bolt (M10x75 mm)
[1 Piece]
[1 Piece]
NUT
#53. Nylon Nut (M10)
[1 Piece]
OTHERS
BOLT
55
40
OLYMPIC ADAPTER
If you intend to use Olympic plates,
slide the Olympic Adapter (#15)
over the standard plate post and
secure it with one
(#39).
Quick Clip
* F O A M R O L L E R S
The
Foam Roller Tube (#12)
can be placed through either
of these two holes depending
on your height. Simply
remove the Round End Cap
(#30)
and one
Foam Roller
(#22) from one end to reposition
the location of the Foam Roller
Tube (#12).
A
B
C
D
9