AR8000 operating manual
50
8-4
MEMORY CHANNEL COPY - alternative method using memory recall
Other AR8000 facilities may be manipulated in order to achieve data copying
of memory channels. In particular memory recall and memory input may be
used to copy frequency, mode and step data but not alphanumeric comment
to another memory location.
To carry out the same example as shown in section 8-3 (COPY-MODE) but
copying the data of memory channel “A00” to “C23” proceed as follows:
Press [SCAN] to access memory recall mode, the legend “M.RE” appears on
the LCD to confirm operation.
Select the memory channel to be copied by keying in the memory location [A]
[0] [0] or by rotating the [DIAL].
Press [ENT] to transfer the data contents of memory channel “A00” to 1VFO.
Press and hold the [ENT] key for more than one second to access a short
memory input menu.
Key in the memory location where you would like the memory data to be
copied [C] [2] [3] or find the location by rotating the [DIAL].
Press [ENT] to confirm the new memory location where the data will be copied.
At this point you may specify up to seven alphanumeric characters for the
“TXT” text comment on line four of the LCD using the [DIAL] and UP/DOWN
keys. If you do not wish to add a comment but wish the data field to remain
blank, or have added a new comment press [ENT].
There is now an identical copy of data 92.7 MHz, WFM, AUTO step and
attenuator off in both memory locations “A00” and “C23” but the “TXT”
comments may be different.
8-5
MOVE-MODE
MOVE-MODE is used to make an exact data copy of one memory channel into
another location in the same way as “COPY-DATA” in section 8-3 of this
manual but the original memory channel is left BLANK (deleted)... The
memory channel data is MOVED rather then COPIED.
To select the “MOVE-MODE” sub menu first access the SET EDIT-CH menu
by pressing [FUNC] [8]. Use the UP/DOWN or [DIAL] until the cursor is to the
left of the “MOVE-MODE” option then press [ENT].
The top line of the LCD will alternately flash between “SET EDIT-CH” and
“MOVE-MODE” to indicate that a sub menu has been selected.
The cursor will be positioned over the memory bank identifier (LETTER).
Use the [DIAL] or keypad to select the memory channel which you would like
to move.
Summary of Contents for AR8000
Page 15: ...AR8000 operating manual 15...
Page 25: ...AR8000 operating manual 25...
Page 29: ...AR8000 operating manual 29...
