40
Introduction to Jumper Settings and Other Connectors
You can clear CMOS to restore system default setting. To clear the CMOS, follow the
procedure below.
1. Turn off the system and unplug the AC power.
2. Remove ATX power cable from connector PWR2.
3. Locate JP14 and short pins 2-3 for a few seconds.
4. Return JP14 to its normal setting by shorting pin 1 & pin 2.
5. Connect ATX power cable back to connector PWR2.
JP14 Clear CMOS
Normal
(default)
Clear CMOS
1
1
Pin 1
JP28 Keyboard / Mouse Wakeup Jumper
You can use JP28 to enable or disable this function,
which could resume your system from suspend mode with
keyboard or mouse. The factory default setting is "Disable"
(1-2), and you may enable this function by setting the
jumper to 2-3.
Disable
(default)
Enable
1
1
Pin 1
TZ65II̲915-OL-E0501A[49.BZ101.0A1].indd
2005/2/17, 下午 10:36
40
Summary of Contents for XC Cube TZ915
Page 3: ...I Getting Start TZ65II 915 OL E0501A 49 BZ101 0A1 indd 2005 2 17 下午 10 32 3 ...
Page 9: ...II Start To Assemble TZ65II 915 OL E0501A 49 BZ101 0A1 indd 2005 2 17 下午 10 32 9 ...
Page 30: ...30 Note TZ65II 915 OL E0501A 49 BZ101 0A1 indd 2005 2 17 下午 10 35 30 ...
Page 31: ...III Turn On The Power TZ65II 915 OL E0501A 49 BZ101 0A1 indd 2005 2 17 下午 10 35 31 ...
