2
nd
USB Channel
1
st
USB Channel
1. JP14 Clear CMOS
2. JP27/28 USB Keyboard/Mouse Wakeup Jumpers
Everything you need to boot this
motherboard is included in this
Easy Installation Guide. For more
information, a complete
Online
User's Manual
can be found in the
Bonus Pack CD
. Thanks for the
help of saving our earth.
PART NO: 49.8AI01.012
DOC. NO: AK79G1394-EG-E0301C
This Easy Installation Guide x 1
User Manual x 1 (for AK79D-1394 and AK79G-1394)
40-Wire IDE Cable x 1 (for AK79D-1394 and AK79G-1394)
80-Wire IDE Cable x 1
Floppy Drive Cable x 1
IEEE1394 Cable x 1 (for AK79D-1394 and AK79G-1394)
I/O Shield x 1
Bonus Pack CD x 1
Anti-Virus CD x 1
This motherboard provides USB and PS2 keyboard / mouse wake-up function. You can use JP27 / JP28 to
enable or disable this function, which can resume your system from suspend mode with keyboard or mouse
installed. JP28 controls 1
st
USB channel, and JP27 controls 2
nd
USB channel. The factory default setting is
set to “Disable”(1-2), and you may enable this function by setting the jumper to 2-3.
You can clear CMOS to restore system default setting. To
clear the CMOS, follow the procedure below.
1. Turn off the system and unplug the AC power.
2. Remove ATX power cable from connector PWR2.
3. Locate JP14 and short pins 2-3 for a few seconds.
4. Return JP14 to its normal setting by shorting pin 1 & pin 2.
5. Connect ATX power cable back to connector PWR2.
Tip: When should I Clear CMOS?
1. Boot fail because of overclocking…
2. Forget password…
3. Troubleshooting…
Normal Operation
(default)
Clear CMOS
1
1
Pin 1
JP27
JP28
Pin 1
Pin 1
1
Disable
(Default)
1
Enable
1
Disable
(Default)
1
Enable
