REV 5 - 1502231100
L-C2-267
4
4.
Connect the bare end of the ignitor wire to the bottom of the
electrode assembly on the infrared burner (see Fig. 4-1).
5.
Attach the other end of the new ignitor wire assembly (the
insulated end) to any connector on the back of the ignitor
(see Fig. 4-2).
Important:
Test the electrodes for spark before securing the
face to the frame (see also the section on battery
replacement in your manual).
6.
Re-install the other ignition wires by plugging them into the
terminals on the ignitor module (Fig. 4-2).
Note:
The wires can be plugged into any terminal.
7.
Affi x the conversion label supplied with this kit to the inside of
the fi re wall behind the face so that it does not obscure any
other labels (Fig. 4-3).
8.
Reinstall the control panel.
9.
Reinstall the drip tray.
10.
Replace the cooking grid.
Note: FLAVOR GRIDS ARE NOT TO BE USED
with infrared
burners.
Fig. 4-1
Connect bare wire to electrode assy.
Fig. 4-3
Apply the conversion label
INSTALLATION (cont.)
Front fi re
wall
Ignitor
electrodes
Insulator
Connect
here
Ignitor
wire
Fig. 4-2
Connect wire to the ignitor module
Original models
"L" series models
