REV 5 - 1502231100
L-C2-267
1
PARTS INCLUDED
1.
Infrared burner
2.
Ignitor wire assembly
3.
Self-tapping sheet-metal screw
4.
Infrared cover
5.
Conversion label
TOOLS REQUIRED
• Phillips
screwdriver
• 9/16 open -end wrench
• 1/4 nut driver or socket wrench
INFRARED BURNER KIT
INSTRUCTIONS
Model # IRB-18
Fig. 1-1
Remove the grids and burner clip
REMOVING THE LEFT MAIN BURNER
1.
Starting with a cool grill (see caution above), open the oven
lid and remove the rotisserie rod if installed.
2.
Remove the cooking grid and fl avor grid from the left-most
burner. Set the cooking grid aside.
The fl avor grid will not
be used with the infrared, and should be stored way.
3.
Remove the left-most burner by fi rst removing the burner clip
(see Fig. 1-1). Lift the back of the burner up and back (see
Fig. 1-2) so that it pulls out from the forward fi re wall opening
and the orifi ce. Retain the burner clip
and burner for future
use, if desired.
4.
Remove the drip tray completely from it’s slot.
Fig. 1-2
Remove the burner
Follow these instructions to install an infrared burner in
your American Outdoor Grill.
CAUTION:
Turn each of the burner control knobs to the
OFF position and close the gas shut-off valve
to the grill. Wait for the grill to cool completely
before beginning this procedure.
American Outdoor Grill
• PO Box 4053 • La Puente, CA 91747
INSTALLATION
Included parts
5
4
3
2
1
NOTE:
This unit has been retrofi tted
with an infrared burner.
Burner clip
