INSTALLATION STEPS
Step 1
• This shower door must be installed into a
stud. Minimum threshold space is required.
IMPORTANT: Using a stud finder,ensure that
the wall on both side of the enclosure has a
stud in the location shown. A stud in this
location must be identified to support the
support bar in order to proceed with the
installation. If you do not have a stud in this
area shown, find a qualified person for advise.
{Fig 1)
1. Place the
Wall Jamb[03]
to the intended
position.Make sure the
Wall Jamb[03]
is
resting on the floor or base and is level.
The end that should be resting on the floor
has a 45
°
angle. Mark the center of the holes
on the wall for the mounting screws.
Step 2
1. Remove the
Wall Jamb[03]
and drill hole
05/16"X1-9/16"(8X4Omm) into the wall
where marked. Place
Wall Plugs [01]
inside
the holes.
2.lf needed, a rubber mallet can be used to
insert
Wall Plugs[01].
3.To reduce risk of property damage, the use
of metal hammers is not recommended. If
needed, use drill to slightly enlarge the
opening of the hole.IMPORTANT:
Wall Plugs
[01]
MUST be used.
LEVEL
-FLOOR
MARK THE HOLES ON
THE WALL
Fig 1
7
