ii
[Precautions for design]
The AnyWire system has high noise resistance, however, keep transmission lines and input/output
cables 100 mm or more (as a guide) away from high-voltage cables or power lines. A malfunction may
result.
Incorporate an emergency stop circuit and an interlock circuit for safety into an external circuit other
than the AnyWire system.
[Precautions for installation]
AnyWire products should be used in environments that meet the general specifications presented in
the User’s Manual.
Using them in environments outside the general specifications may result in injuries due to electric
shock, fire, malfunctions and/or damage to or degradation of the products.
Install respective products properly. Improper installations may cause malfunctions, failures and/or
falls.
If they are to be installed on a DIN rail, ensure to orient the products so that the fixed hooks would be
on top.
Holding them with the movable hooks on top may cause devices to fall due to vibrations or the weight
of cables.
It is strongly recommended to use DIN rail stoppers for secure installation.
If screws were used to install them, fasten screws within the torque specified for respective screws.
Loose screws or screws fastened too tight may cause damage, dropout and/or malfunction of the
devices.
To install and remove the devices, always ensure that all phases of external power supplies used in the
system are shut down.
Failing to do so may result in damages and/or malfunctions due to sneak current.
Do not touch energized parts and electronic components with a bare hand. Doing so may cause
malfunctions and/or failures.
CAUTION
WARNING
