ATSC 25W TX Quick Start Guide
ACT-25-QSG-DOC-V1.2, 09/29/2014
Page 9 of 13
5
Initial Turn On
Please locate and have handy for reference a copy of your
25W TX Factory Test
Report
as well as the
25W TX Quick Start Guide
, and
25W PA and Exciter
User Manuals.
1.
With all equipment turned OFF, please make the cable connections according
to the System Interconnect Diagram of section 4. Make sure the BPF or PA
output is properly connected to your Antenna feed or a suitable station load
before proceeding further.
2.
Turn ON the Exciter via its rear panel AC switch.
3.
Check Exciter settings. Check the operating Frequency of the Exciter by
navigating to the Exciter FREQ submenu (simultaneously press Left and Right
buttons)
Check the Exciter drive level is set to -25dBm by navigating to the Exciter
RF submenu (from above, press ESC button then enter the RF submenu).
(Please refer to your Exciter User Manual for help with detailed operation of
the Exciter).
4.
Turn the 25W PA ON via the PA rear panel breaker, then press the front panel
PA RF On/Off button to turn ON the PA - which should turn BLUE when ON.
5.
The built-in Exciter %FWD power meter has already been calibrated at the
factory to indicate 100% for 30W of TX system forward power measured after
the BPF.
