AnyTone 5888UV III, User Manual

Page: 3 / 39

NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference o radio or television
reception, which can be determined by turning the equipment off and on,
the user encouraged to try to correct the interference by one or more of
the following measure:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
Precautions
Please observe the following precautions to prevent fire,
personal injury, or transceiver damage:
Do not attempt to configure your transceiver while driving, it
is dangerous.
This transceiver is designed for a 13.8V DC power supply.
Don't use a 24V battery to power on the transceiver.
Do not place the transceiver in excessively dusty, humid or
wet areas, nor unstable surfaces.
P l e a s e k e e p i t a w a y f r o m
interferential devices (such as TV,
generator etc.)
Do not expose the transceiver to
long periods of direct sunlight nor
place it close to heating appliances.
If an abnormal odor or smoke is
detected coming from the transceiver, turn OFF the power
immediately. Contact an Anytone service station or your
dealer.