AnyTone 5888UV III, User Manual

Page: 15 / 39

10
SelectinG the FRequency bAnd
This transceiver can be set working on 2 UHF band or 2 VHF band.
input chAnnel thRouGh MicRophone nuMbeR key
In channel mode, you can switch to desired channel by press 3 of the
microphone numeric keys (001-750). For example input 001 get channel
1; input 030 is channel 30; input 512 is channel 512. If the input channel
is no frequency, the transceiver will emit a warning beep and return to last
channel.
1. Choose for Left band: press the left side key to switch it to VFO
mode, press the left selector knob over 1 second then repeat above
operation will switch the left band.
2. Choose for right band: press the right side key to switch it to VFO
mode, press the right selector knob over 1 second then repeat above
operation will switch the right band.
5
Basic Operations
ReceiVinG
If the transceiver has set at higher squelch level, it may fail to hear the
calling. If the
“BUSY”
and signal strength icon display in left band or
right band, but can not hear the calling, means the signal is with matching
carrier but dis-matching signaling.
In standby, both left band and right band are
able To receive. When they receive any signal,
the “BUSY” icon and signal strength icon will appear in the corresponding
area of the LCD. And you can hear the calling.
Squelch oFF/Squelch oFF MoMentARy
Long press of key can be set up as Squelch Off or Squelch Off
Momentary to monitor the weak signal.
1. Squelch Off: Hold
key until hear "Du" beep, the squelch is off,
repeat the above operation to resume squelch.
2. Squelch Off Momentary: Keep hold key to disable squelch,
release the key to resume squelch.
In standby, press the microphone to cancel squelch, press it again
to turn on the squelch.
NOTE
NOTE
NOTE