Programming the Output# 2 Function
Output #2 can be activated via * or through user codes. Use the following steps to program its function.
DEFAULT: User Codes
Step 1 Enter: *2
Step 2 For user codes, enter 01
For door bell, enter 02
When output #2 is programmed for doorbell, press * to activate doorbell. Doorbell output lasts 1 second.
◆
Factory Default:
NOTE: Resetting the keypad will cause some or all programmed data to be lost. Do not perform either of these
steps unless it is absolutely necessary.
Deleting All Users: Enter * 8 8 8
IMPORTANT: Once key entry is made, all user codes will be deleted and the keypad will return to Programming
Mode. The Master Code and all other programming settings will remain the same.
Restore Factory Settings: Enter * 8 9 9
IMPORTANT: Once key entry is made, keypad will return to factory default settings. No user information will be
retained and the Master Code will be 1234.
Manually Resetting the Master Code:
If the Master Code has been forgotten or does no work, the following steps can be taken to reset the Master Code:
1. Disconnect power from the keypad.
2. Press the # key continuously and connect power again.
3. The keypad will beep to confirm a successful reset.
Note: Manually resetting the Master Code will only reset the Master Code. It will not affect the Master Code,
User Code or any other saved data.
Code Length
4 digits
◆
Factory Default:
Master Code
1234
Output #1 Access Mode
User codes
Output #1 User Codes
None
Output #2 User Codes
None
Output #1 Timer
1 second
Output #2 Timer
1 second
Output #2 Function
User codes
Copyright © All rights reserved. P-MU-DG-750 Published 2019.07.01
