SAFETY
1. When this appliances is to be positioned in close proximity
to a wall, partitions, kitchen furniture, decorative finishes, etc.
it is recommended that they be made of non-combustible mate-
rial. If not, they shall be clad with a suitable non-combustible
heat insulating material, and the closest attention be paid to fire
prevention regulations.
2. Use the appliances on an individual 15A mains outlet only.
DO NOT OVERLOAD THE CIRCUIT.
3. Ensure that the equipment and the power supply cord does not
come into contact with hot surfaces.
4. Supervision is necessary when the appliance is used in close
proximity to children.
5. If the supply cord is damaged, it must be replaced with a new
cord assembly available from the suppliers agent.
6. Use only earthed outlets matching the serial plate voltage.
7. Have equipment installed by a qualified personnel in accordance
with local codes and ordinances.
8. Use equipment in a flat level position.
9. Do not operate unattended
10. The equipment may be hot, even though the pilot light is not on.
11. Do not operate if equipment has been damaged or is malfunc-
tioning in any way.
12. These appliances are designed to run only on alternating current
(A.C.) DO NOT CONNECT TO DIRECT CURRENT (D.C)
WARNING
Electric Shock Hazard.
Keep water and other liquids from entering the inside
of the equipment. Liquid inside the equipment could
cause an electrical shock
Do not spray water or cleaning products. Liquid could contact the
electrical components and cause a short circuit or an electrical shock.
Do not use equipment if power cord is damaged or has been modified
READ ALL INSTRUCTIONS BEFORE USE. FAILURE TO
FOLLOW THESE PRECAUTIONS COULD RESULT IN INJURY TO
YOURSELF AND OTHERS
Part
No.
1
TOP HINGE AXLE M8
2
9 SLICE TOASTER HANDLE
3
STAINLESS STEEL TOASTER HANDLE
4
PLASTIC TOASTER HANDLE
5
STAINLESS STEEL PRESSED COVER
6
M5 HEX SPACERS
7
TOP ELEMENT COVER PLATE
8
5MM MILL BOARD TOP
9
TOP ELEMENT 1050W
10
ALUMINIUM TOP CASTING
11
BOTTOM ELEMENT 920W
12
CONTROL FACIA PANEL
13
PILOT LIGHT
14
KNOB
15
BEZEL
16
CONTROL PANEL INSERT
17
ANVIL AXIS LOGO
18
THERMOSTAT
19
STAINLESS STEEL BODY
20
M5 PLATED EYE BOLT
21
SMALL RUBBER FEET
22
GALVANISED COVERPLATE
23
BOTTOM ELEMENT COVER
24
BOTTOM INSULATION PAD
25
BOTTOM HINGE AXLE M8
26
CABLE GRIP
27
POWER CORD
28
HANDLE ADJUSTMENT SCREW
29
HANDLE HINGE GRACKET
30
ALUMINIUM BOTTOM CASTING
31
HANDLE SPRING
32
DRIP CUP
33
SPRING BRACKET
Description
MODEL: SANDWICH PRESS - FLAT BOTTOM, RIBBED TOP
(NON TEFLON)
MODEL CODE : TSA6009 R01
