Antx DiaLog Elite, Manual

Page: 14 / 28

DiaLog Elite PLC Interface Manual
From the front panel
All programming prompts are spoken and shown on the display.
To program the Modbus Master Interface settings:
What you do: What DiaLog says:
Press
Home
1
PROG
(PROG mode)
“Programming mode activated. System ready.
Enter selection.”
Press
8
(Options Setup)
“Options setup. Enter selection.”
Press
0
Status
Valid values are:
1200
2400
4800
9600
19200
38400 - default
115200
“ Serial Port Setup . Press Pound (#) if OK or enter
a new value.”
Enter your baud rate. For example:
9 6 0 0 # .
“The new rate is 9 thousand 6 hundred. Enter
selection.”
Press
2
Run
“ MODBUS PLC Setup . Enter selection.”
Press
0
Status
Enter the Modbus ID for the PLC.
For example:
“The PLC ID number is 1. Press Pound (#) if OK
or enter a new value.”
0 0 5 “The new PLC ID number is 5. Enter selection”
.
4
Version 1.2
©
Antx, inc. 2001