MSS-200 MINI SPATULA STEAMER
7
P/N 1010903 Rev. A 09/05
INSTALLATION (continued)
Figure 3. Dual Water Pressure Regulator
Installing the Dual Water Pressure
Regulator
The Dual Water Pressure Regulator (Figure 3) can be
installed in any of the following ways:
• On a vertical surface (Figure 4)
• On a horizontal surface (Figure 4)
• Free-Standing (not mounted) (Figure 4)
When mounting the Dual Water Pressure Regulator
onto a fixed horizontal or vertical surface, you must
use the mounting screws provided with the kit. These
screws are self-tapping and require a 0.125” inch hole
for mounting.
A free-standing mounting does not require use of the
mounting screws.
WARNING
DO NOT mount the Dual Water Pressure Regulator
over an electrical outlet or any other appliance or
area that may be damaged by water or that may
cause personal injury.
Water
Strainer
Water
Supply Inlet
Connection
Water Pressure
Regulator
Preset to 30
PSI and Fixed
(not adjustable)
Water Pressure
Regulator Gauge
Set to 7 to 9 PSI
(adjustable)
Water Supply Outlet (to
Mini Spatula Steamer)
Holes for verti-
cal mounting
(7 inches
apart).
7.5 inches
between
mounting
holes.
Figure 4. Mounting Options
For horizontal
mounting
Checking and Cleaning the Water Strainer
The Water Strainer protects your equipment from any
foreign debris in the water line that could get into the
food and damage the unit’s solenoid (causing the unit
to leak or flood), It protects from interference with the
equipment’s proper and consistent operation
To ensure proper and consistent steaming results,
check the water pressure regulator gauge and strainer
cup regularly. If the pressure on the gauge has
dropped, check the clear, plastic strainer “cup” and
clean out the accumulated debris as follows.
1. Press the Release Tab and remove the Quick
Disconnect Fitting #2 (Figure 5). Unscrew the
clear, plastic strainer “cup” and carefully remove
the mesh strainer screen (Figure 5).
NOTE: Some water may drip out from the Quick
Disconnect fitting and Strainer Cup.
2. At the sink, gently flush all of the accumulated
debris from the strainer cup and mesh strainer.
Be especially careful not to damage the mesh
strainer screen.
