GST-3V BUN TOASTER
7
P/N 1012002 Rev. B 04/18
OPERATION (continued)
4. Press the
PROGRAM
button to proceed to the
Front Heater Setpoint Temperature.
5. To adjust the Front Heater Setpoint Temperature,
press the
LIGHTER
or
DARKER
buttons to reach
the desired temperature.
NOTE: The recommended temperature setting for
the front Platen is 271° C (520° F).
6. Press the
PROGRAM
button to procedure to the
Motor Speed Setpoint.
7. Adjust the Motor Speed Setpoint by pressing
the
LIGHTER
or
DARKER
buttons to reach the
desired speed.
NOTE: The Motor Speed is adjustable from 1-100.
The recommended setting is 75.
8. Press the
PROGRAM
button to proceed to the
Temperature Units.
9. To change the Temperatures units from
Fahrenheit or Celsius, press the
LIGHTER
or
DARKER
buttons.
10. Press the
PROGRAM
button to proceed
to the Ambient Temperature of the Control
Compartment.
NOTE: No changes can be made to the Ambient
Temperature of the Control Compartment.
Temperatures under 150° F (66° C) are acceptable.
11. Press and hold the
PROGRAM
button to save
any changes.
NOTE: The unit exits Manager Mode after 30 sec-
onds of keypad inactivity.
Safety Features
HI-LIMIT CONTROL
A Hi-Limit Control turns off electrical power to the heat-
ers and control circuits if the unit overheats. To reset
the control:
1. Allow 10 - 15 minutes for the unit to cool.
2. Locate the two Hi-Limit Controls on the rear of the
unit. Remove the two black protective caps.
3. Press and release both buttons. Reinstall the pro-
tective caps.
NOTE: If the Hi-Limit Controls require continuous
resetting, contact your Authorized Service Agency.
Purging buns from Toaster
If buns get stuck in the toaster, press and hold both
the
UP
and
DOWN
arrow buttons to increase the belt
speed until the buns are purged from the toaster.
There are variations in bun products that are used
on the A.J Antunes GST-3V toaster such as moisture
content, bun formulations, age, tolerances etc. The
GST-3V was designed to compensate for bun variations
by allowing user to adjust the compression, light/dark
(speed) & temperatures settings in order to achieve a
Gold Standard toasted product.
1.
LIGHT DARK ADJUSTMENT
: Adjust the light dark
setting with the
▲
or
▼
buttons. The default light/dark
setting on the GST-3V from the factory is 0 but can be
adjusted from Lighter 0-10 to Darker 0-10. Light 10 is
the lightest setting and dark 10 is the darkest. Each
increase in “lighter” value will increase the pass through
time and each increase in “darker” value will decrease
the pass through time.
2.
TEMPERATURE ADJUSTMENT
: Adjust the set
point temperature on the platens in the program menu.
The default temperature settings on the GST-3V are A
Platen: 271°C (520°F) and B Platen: 257°C (495° F) .
The temperatures can be increased to +/- 50°F (10°C) if
needed to achieve an acceptable toast quality.
3.
COMPRESSION ADJUSTMENT
: Adjust the compres-
sion knob on the left side of the unit. The default com-
pression setting on the GST-3V is 4 but is adjustable
from 1-7. It is acceptable to adjust the compression
from 1-7 as needed to achieve the desired toast quality
and bun compression.
