Universal ToasTer UTX-200
15
P/N 1010904 Rev. B 03/12
McDonald’s
A.J. Antunes & Co.
Figure 8. Master Links
Screws
2. Apply
Mcd© all-Purpose super Concentrate
(aPsC) (HCs)
on a
non-scratch
pad and clean
the vertical Conveyor Belt for two complete revo-
lutions, wiping side to side. Use the dual holes in
the master links as a reference (see Figure 8).
5. Insert the Release Sheet Retainer Bar into the top
of the Release Sheet.
6. hang the Release Sheet Retainer Bar and
Release sheet onto the top of the unit.
note: rotate the release sheet from side to side
daily to extend the life of the release sheet.
7. Reattach all accessories to the unit (Figure 2).
NOTE: Check the Release Sheet to make sure it is
draped properly over the Platen.
MaintenanCe (continued)
Figure 9. Back Panel Release Latches
SELECT
SELECT
LOCKED
UNLOCKED
(Horizontal)
(Vertical)
release latches (on
botH sides of the rear of
the unit) are locked when
in the horizontal position.
Close the Back Panel
and turn both latches to
the horizontal position to
secure the Back Panel
3. Press and hold both
MUffin/baGel
selec-
tor buttons on the back of the unit (Figure 6) to
expose the uncleaned portion of the belt. Repeat
Step 2 on the uncleaned portion of the belt.
iMPortant
if the vertical Conveyor belt appears yellow/
brown, repeat steps 2 and 3 using a Mcdonald’s
approved Grill Cleaner. the vertical Conveyor belt
should be silver/metallic when cleaned properly.
4. Rinse/wipe the vertical Conveyor Belt with
the grain (Side to side) using
KaYQUat ii™
Sanitizer Solution (HCS)
and allow to air dry.
NOTE: Do not leave the Back Panel open any lon
-
ger than it takes to complete these cleaning pro
-
cedures. refer to the cleaning label located on the
back of the unit.
8. verify that the Bun Thickness Compression
Control knob is set to 3 (Figure 5).
9. Close the Back Panel and lock the Back Panel
Release Latches (Figure 9).
10. Place the toaster back into operation.
