Antti-Teollisuus Oy
8
408107
09-2016
Optivol
Installing the Optivol limit sensor inside the drying section
The limit sensor, included in the delivery, shall be installed in the overhead drying section or in the top tank. The
correct installation location is presented in the drawing. The installation plate for the sensor shall be attached to
the end plate using self-drilling screws.
Using external exhaust pipe clamps, position the Optivol in the air duct shafts. Place the clamps on either side of
the Optivol, centered with the clamps on the leverage. Put first in place the clamp on the drying section side, and
after that, put the cover in place, and fasten the outer clamp.
NOTE! In the StandAlone models, the limit sensor shall be installed before insulating the unit.
