REPLACEMENT OF BATTERIES
1) Detach the auto darkening filter from the helmet shield (Refer to REPLACEMENT OF
WELDING FILTER)
2) Carefully open the battery compartments.
3) Put the new batteries into the compartments. (Fig.10)
4)Snap the compartments back into the filter.
5)Install the filter back onto the helmet shield.
5.MAINTENANCE
-9-
-10-
4. PRE-WELDING CHECK & BATTERY TESTING
The following procedures should be followed to
perform this testing:
1) Make sure there is enough ambient light to
trigger the auto darkening lens on.
2) Make sure that "Grind/Weld" switch (Fig.5) is on
"Weld" position.
3) Press and hold on the "Batt" button(Fig9) for a
second or two:
If the LED (Fig9) is ON, and the lens is darken as
per shade setting, the helmet is functioning
properly.
If the LED is NOT on when procedures above are
followed, battery replacement is required.
If the LED is ON and LCD is not darkening as per
shade setting, the auto darkening lens may be
defective.
Always test the auto darkening
lens before welding.
NEVER put used batteries into house hold waste because they are very toxic to the environment.
Please always have used batteries recycled properly, and stay GREEN when welding.
Always change both of the batteries when renewing them.
AntFi-X60-3
AntFi-X60-2
AntFi-X60-8
AntFi-X60-6
+
+
AntFi-X60-3
+
+
AntFi-X60-6
+
+
AntFi-X60-2
AntFi-X60-8
(Fig.9)
(Fig.10)
Take out the old cover lens (Fig.11).
Make sure that the protective film is removed from
the new cover lens.
Place the new cover lens in the recess at the front
of the helmet (Fig.12).
Ensure the front cover lens is mounted before
using and the protective film on the lens cover is
removed.
Ensure that the lens is clean and there is no dirt
or spatter covering the 4 sensors at the front of
the filter cartridge.
REPLACEMENT OF INNER COVER LENS
Detach the auto darkening filter from the helmet
shield (Refer to REPLACEMENT OF WELDING
FILTER).
Lift up one edge of the inner cover lens and pull the
cover lens away from the filter(Fig.13).
Remove protective film on the new inner lens cover,
feed one side of the lens cover (Fig.14) onto lens
retaining slots on the filter, then push it slightly all
the way until the whole lens cover is snapped on
properly.
(Fig.11)
(Fig.12)
MAINTENANCE : AH6-260-XXXX AH7-360-XXXX AH6-660-XXXX
LED
LED
LED
LED
(Fig.13)
(Fig.14)
