Elevate,
TM
Electric Lift Table Assembly Instructions
7
STEP 10
Home the Legs
Legs must be homed any time the table and legs are disconnected from power. If the legs are not homed at both the top and
the bottom, the table will only move at half its normal speed.
¡
Press down button until the table reaches its lowest point and stops moving. Release the button for 1-2 seconds. Press
down button again for 3-5 seconds and you will see the table home itself.
¡
Press up button until the table tops at the highest point and hold for 3-5 seconds. Press the down button for 2-3
seconds, then the up button again until it tops at the highest point and hold again for 3-5 seconds. (The goal is to have
the table hold at it’s highest point twice.)
¡
If the legs ever fail to function properly, unplug the power cord, wait 10 seconds, plug the power cord back in and repeat
the above steps.
STEP 11
Add Accessories and Install Your Equipment
¡
Now add your Anthro accessories and install your equipment.
¡
A word of caution: the height range of Elevate may be longer than the cords on your equipment. Equipment that is
mounted in a SideRack w/Caster or Equipment Shelf, for example, will not move up and down with the table. Raise and
lower the table to its highest and lowest positions when all equipment is installed to make sure that the cords are long
enough. Double-check that all the table's cords and cables reach comfortably through the table's entire range of motion.
CONGRATULATIONS! YOUR ELEVATE TABLE ASSEMBLY IS COMPLETE!
