Anthem MDX Crestron
Module
Input Signals
Enable
[digital]
When this signal is high the module will communicate with the anthem. When the signal
goes low the module will not send out any data.
TCPConnected
[digital]
This signal needs to be connected to the TCP/IP Client symbol on the Connect-F signal. The
module will not send out any data until this signal goes high. NOTE: This signal only takes
effect if the connection type is set to TCP.
GetStatus
[digital]
This signal is used to refresh the current state of the MDX rather than wait for the next
polling period.
ZonePower[1-8]
[digital]
Raising this signal will power the matching zone on, lowering it will power the matching
zone off. The signals from 5 - 8 are designed to be commented out if you are using the
MDX-8.
ZoneMute[1-8]
[digital]
Raising this signal will mute the volume of the matching zone, lowering it will un-mute the
selected zone. The signals from 5 - 8 are designed to be commented out if you are using
the MDX-8.
5
