5
BREAK-IN TIME
As with all audio electronic products, the ultimate sonic
character of the MCA Amplifiers will not be realized until and
unless the unit receives a minimum of approximately 70
hours of signal break-in time (i.e. the amplifier is on and
outputting a signal).
PLACEMENT FOR PROPER VENTILATION
The MCA Series require a minimum of 12” (30cm) above, of
unobstructed air space. Make sure that the ventilation slots
on the top and bottom remain unobstructed by any object.
Do not stack any other component on top of the amplifier
or block the ventilation slots in any way. Also, be sure that
the amplifier is placed on a secure, hard and level surface,
NOT
on carpet.
In the event of overheating, your MCA amplifier is equipped
with a thermal shut off feature. The amplifier will remain off
until the temperature falls below the shut off threshold.
Once this condition is met, the amplifier will reset itself and
it can be powered on again.
PACKING MATERIALS
Please retain all of the packing material and shipping boxes
for your MCA Amplifier. They are custom designed to
prevent shipping damage from occurring. Sonic Frontiers
Int’l will accept no responsibility for any damage occurring
to an MCA Amplifier that is shipped in packing material
other than the original Sonic Frontiers packing material.
DISCLAIMER OF LIABILITY
Under no circumstances does Sonic Frontiers Int’l assume
liability or responsibility for injury or damages sustained in
the use or operation of this equipment or for damages to
any other equipment connected to it.
Sonic Frontiers Int’l reserves the right to make design
changes or improvements without the obligation to revise
prior versions. All specifications are subject to change
without notice.
TROUBLESHOOTING
If at any time the MCA Amplifier fails to work properly, consult
this checklist:
1. Check that the AC Detachable Power Cord is plugged into
the Detachable Power Cord Socket (E) and is connected to a
live source of AC power. For instance, if using a power bar,
check that the bar is turned on.
2. Ensure that all Input and Output connections are secure for
a proper electrical contact.
3.Ensure that the amplifier is configured for the appropriate ON
MODE in your system setup.
If a problem still persists, please contact your authorized
Anthem Dealer or the Factory directly.
