Anthem LTX-500, Instructions Manual

Page: 35 / 182

ENGLISH
35
Getting Started
Preparation
Basic Operation
Troubleshooting
Settings
Others
4 Select the
“
Hue
”
,
“
Saturation
”
or
“
Brightness
”
using the / button.
5
Use the / button to adjust.
●
You can switch between
“
Before
”
and
“
After
”
using the [TEST] button of the remote control.
6
To end
Input Signal > HDMI
11
HDMI
Con fi gures HDMI input signal.
Input
Auto Automatically con fi gures the input signals.
Standard
Select this when the dynamic range of the input images is
16-235.
Enhanced
Select this when the dynamic range of the input images is
0-255.
Color Space
Auto Automatically con fi gures the input signals.
YCbCr(4:4:4)
Select this when the Y Cb Cr(4:4:4) video signals are
input.
YCbCr(4:2:2)
Select this when the Y Cb Cr(4:2:2) video signals are
input.
RGB Select this when the RGB video signals are input.
Control with HDMI
On Enables CEC communications.
Off Disables CEC communications.
●
The setting is available only if the HDMI terminal is selected.
●
Abbreviation
CEC: Consumer Electronics Control
Input Signal > COMP.
12
COMP.
Con fi gures the input signal for the component video input terminals.
Color Space
Y Pb/Cb Pr/Cr Select this when the component video signals are input.
RGB Select this when the RGB video signals are input.
SCART
Select this when RGB video signals and sync signals are
input via the SCART interface for European markets.
●
The setting is available only if the component video terminals are selected.
7
Hue
Check
TEST
After
BACK BACK
OK
BACK
Yes
No
Save Color Management?