58
4. OPERATION
continued …
4.13 ENABLE / DISABLE TIMERS
(Remote Control Only)
To enable or disable all timers without entering the Setup, press and hold the
SLEEP
key until the display
shows ‘ALL TIMERS’, then use the
keys to enable/disable (see section 3.1).
4.14
STATUS DISPLAY
Press, Release, Press to cycle through display screens that show the following:
• Software version
,
day
, and
time
.
• Video Input:
Resolution and refresh rate of video source, and
copy-protection status – “
CP
” means copy-protected, “
NP
”
means not protected. (See section 2.1.)
• Audio Input:
Bit rate / sample rate of digital source, or Analog.
• Input Format:
Channels in the source.
• Audio Output:
Bit rate / sample rate mode of the digital to analog converters.
• Output Format:
Channels producing output.
• Mode:
Surround mode (section 4.8).
• DD/DTS 5.1 Dynamics:
Normal, Reduced, or Late Night (section 4.8.10).
• Tone Controls:
Enabled, Bypassed, or N/A (section 4.7).
• Sleep Mode:
Enabled or Disabled (section 4.12).
• All Timers:
Enabled or Disabled (sections 3.1 and 4.13).
• Serial Number:
If the number on the rear panel does not match this, contact Anthem immediately.
When in ZONE2 or ZONE3, information relating only to the selected Path is displayed.
STATUS
SELECT
