4
VI.
INSTALLATION OF WIRE HARNESS ON
ROOF
1. A.
Using a 1-1/4” hole saw, gently cut
upwards through the first layer of the ceiling from
the inside of the Predetermined cabinet.
NOTE: If there is a vinyl covering on the
ceiling, use a utility knife to cut a hole first.
This will prevent the hole saw from tearing the
vinyl.
Controller front view
LCD Display
Light
Start
button
Figure 5
Data port
OFF ON
12v DC
Controller rear view
Figure 4
Pre- Marked area
Silicon Adhesive
dish mounting bracket is in the vertical position
(90 degrees), press the Start button so Dish stops
and remains in the vertical position to allow
access to the base plate for mounting on the roof.
Using (4) 1/4 x 3/8 screws and nuts attach the
Dish to the mounting bracket.
NOTE: Rotate dish with azimuth motor to
allow for easy access around dish.
3. A.
Before returning dish to travel position,
outline baseplate on roof using a marking pen.
B.
Carefully set aside the Lift ASM and use
silicone adhesive on the pre-marked areas.
Cover entire area as shown (Fig. 3).
C.
Set Lift ASM down over the silicone
adhesive.
D.
Secure baseplate to roof using #10 x 1”
Mounting screws. To prevent leakage, coat the
top of each screw head with silicone sealant.
CAUTION: Do not over tighten as holes in roof
may strip out.
Figure 3
34"
20"
123456789012345678901234567890121
123456789012345678901234567890121
123456789012345678901234567890121
123456789012345678901234567890121
Figure 1
Figure 2
6.75"
Cable from Motors
-
+
N/C
Roof
