-10-
-11-
1
Fill the fuel tank full and turn on your diesel generator (if you are using the mains
electricity network, go directly to point
2
).
2
Connect a current stabiliser to the 120/230 V (alternating current) electrical power
socket, and switch it on.
3
Connect the WATA-Plus
®
device to the 12 V/29.2 A power supply.
4
Connect the 12 V/29.2 A power source to the stabiliser and turn the power source’s
green switch to on.
5
Wait 4 hours to generate 15 litres of sodium hypochlorite solution (6 g/L).
6
At the end of the process, turn the power source green switch to off. Disconnect the
12 V/29.2 A power supply from the stabiliser.
7
Remove the WATA-Plus
®
device from the bath, and then disconnect the 2 WATA-Plus
®
cables. Turn the stabiliser’s switch to off.
8
Unplug the stabiliser from the wall socket. Rinse the WATA-Plus
®
device in clean water,
then store it out of harm’s way in a dry place. Protect it by covering with a clean cloth.
6.2 PREPARING THE SOLUTION FOR ELECTROLYSIS
WITH COARSE OR DIRTY SALT (15L BASE)
1
Pour 3 litres of clean water into a clean plastic container.
2
Add 375 grams of salt.
3
Regularly shake/mix for 15 minutes so that the maximum amount of salt dissolves.
4
Allow the salt’s impurities to settle at the bottom of the container. At this point, the
salt is dissolved in the water.
5
Pour 12 litres of water into a plastic container (never use metal).
6
Place a filter (e.g. a coffee filter or a clean, very finely-woven cloth) over the container
and add the 3 litres of water containing the pre-dissolved salt. Mix well.
7
Immerse the body of the WATA-Plus
®
in the salt water: the handle should remain out of
the water, but the body of the device should be completely submerged.
6.3 INSTALLING AND CONNECTING
THE WATA-PLUS
®
DEVICE
W
You are advised to install a stabiliser between the power source and the 12 V/29.2 A
power source. Have the electrical system’s stability inspected by a specialist.
W
Using a diesel generator (or generator unit), the recommended minimum power is
3 kW/kVA.
W
The power source must be located as far as possible away from the water-
production container, so as to protect it from the highly-corrosive chlorine vapour.
The power source must not be laid on the ground. Ideally, it should be placed in a
room other than the chlorine production room.
3 L
1
2
3
4
12 L
3 L
15 L
WATA-Plus
www.antenna.ch
5
6
7
WATA-Plus
www.antenna.ch
6 m
Power
supply
2
1
3
4
15 L = 4h
WATA-Plus
www.antenna.ch
5
6
7
8
Generator (unit)
min. 3 kW
Stabiliser
WATA-Plus
®
