5
H
ARDWARE
I
NSTALLATION
G
UIDE
2.1
R
EMOVING THE TOP PANEL
Place the case flat on an even, stable surface.
1.
Remove the three thumbscrews from the rear of the
top panel.
2.
Grip the top panel and slide it back several inches
until it stops.
3.
Grip the panel from the sides and lift it up until it
pulls completely free of the main chassis.
Note
: Do not use your fingernails to pry or lift the
panels.
2.2 R
EMOVING THE DRIVE TRAY ASSEMBLY
Remove the top panel as detailed in section 2.1.
1.
Using a Phillips-head screwdriver, remove the three screws on the
top of the tray that attach it to the chassis.
2.
Grip the tray in the middle and pull it a few inches toward the rear
of the case until it pulls loose.
3.
Pull the drive tray assembly up and completely free of the chassis.
2.3
M
OTHERBOARD
I
NSTALLATION
Remove the top panel and remove the drive tray assembly as detailed in sections 2.1 and 2.2.
1.
Lay the case down, with the open side facing up. The drive cages and
power supply should be visible.
2.
Make sure you have the correct I/O panel for your motherboard. If
the panel provided with the case isn’t suitable, please contact your
motherboard manufacturer for the correct I/O panel. Install the I/O
panel at the rear of the case.
3.
Align your motherboard with the motherboard standoff holes
located at the rear of the case.
4.
Screw in your motherboard to the standoffs with the provided
Phillips-head screws.
Your motherboard is now installed.
Summary of Contents for ISK 310-150
Page 1: ...ISK 310 150 USER S MANUAL ...
