Antec Scientific VT-03, User Manual, Page: 33 / 36

CHAPTER 4 Maintenance 33
3. Polishing the electrode surface
Polishing
1. Shake diamond slurry thoroughly before use!!
2. Rinse the polishing disc with demi water before applying the
diamond slurry!
3. Apply a small amount, a few drops is sufficient, of slurry on the
wetted polishing disc, and polish the electrode with a ‘figure 8’
motion for about one minute. Apply only gentle pressure.
4. Clean the electrode with an ethanol-wetted tissue and check the
surface visually; repeat the procedure if necessary.
5. Reassemble the detector cell.
6. Clean the polishing disc with demi water.
7. Store the polishing disc dust free in its plastic bag.