Antari Z-Stream, User Manual

Page: 9 / 12

9
After every 40 hours of operation, it is recommended to run distilled water through the system to
prevent the heater clog.
Cleaning your fog machine regularly will help reduce costly parts replacement and repair
charges.
Important
Always monitor tank fluid level as you are fogging. Running a fog machine without fluid can
permanently damage the unit. If you experience low output, pump noise or no output at all, unplug
immediately. Check fluid level, the external fuse, remote connection, and power from the wall. If all of
the above appears to be O.K., plug the unit again.
If fog does not come out after pressing the remote button for 30 seconds, check the tube attached to
the tank to make sure there is fluid going through inside.
If you are unable to determine the cause of the problem, do not simply continue pressing the remote
button, as this may damage the machine. Return the machine to your dealer for inspection.
Performance Notes

All fog machines develop condensation around the output nozzle. Because this may result in
some moisture accumulation on the surface below the output nozzle, consider this
condensation when installing your machine.

Fog machines may spit small amounts of fog occasionally during operation and for a minute or
so after being turned off.

Z-Stream fog machine has a heating cycle after bursts of fog so the machine stops fogging for
a short period in order to reheat. During this time no fog can be produced.

Only use Antari fog liquids.
Save these instructions